![]() ![]() Added an Assign remote Fn button at Position f15 in the CUSTOM SETTING MENU. *.With the addition of Assign movie record button at Position f13 in the CUSTOM SETTING MENU, the Assign MB-D12 AF-ON option in the CUSTOM SETTING MENU has been reassigned to Position f14.Added Assign movie record button at Position f13 in the CUSTOM SETTING MENU. *.- When photos were taken using Camera Control Pro 2 after Custom Setting d10 ( Exposure delay mode) was enabled in the CUSTOM SETTING MENU, the software would sometimes mistakenly display a message stating that no photo could be taken.Ĭhanges from Previous Versions Changes from Firmware “A” Version 1.01/“B” Version 1.02 to “A”/“B” Version 1.10.- When focus is adjusted by rotating the lens focus ring, the focus indicator in the viewfinder (and in live view, the focus point in the monitor) now flash to indicate when infinity or the minimum focus distance is reached.- If the standby timer expires after focusing, the focus position will no longer change when the timer is reactivated.Added the following supports for AF-P lenses:.Settings saved with firmware “A” version 1.01/“B” version 1.02 or earlier are not compatible with D800E “A”/“B” firmware version 1.10 or later.Ĭhanges from “A”/“B” Firmware Version 1.10 to Version 1.11 Do not attempt to load settings saved using Save/load settings for firmware “A” version 1.01/“B” version 1.02 or earlier onto a D800E with “A”/“B” firmware version 1.10 or later.Before proceeding with the update, users of Lexar 400× and 1000× CompactFlash ® memory cards will need to follow the steps here to check compatibility.Read the information below before proceeding.You will not need to download or install this update if the firmware listed above is already installed. Before proceeding, select Firmware version in the camera SETUP MENU and check the camera firmware version. The update can be performed on both the “A” and “B” firmware simultaneously. This service supplies software that can be used to update the D800E camera “A” and “B” firmware to version 1.11.Be sure you understand the terms of the agreement before beginning download. By selecting “Accept” and clicking “Download”, you are held to have accepted the terms and conditions of the agreement. ![]() This software update program is for the customer-owned product listed above (the “affected product”), and is provided only on acceptance of the agreement listed below. ![]()
0 Comments
Leave a Reply. |